BMW Fault Code - 9

Check 9 Fault Code

BMW Fault Code: 9

9 - Potentiometer supply voltage 1 of throttle valve 1/2 deviates (OBD II code P0601)

System: Electronic Engine Power Control

BMW System: EML

Type: Drive

AirCon Compressor

Fault Code Table : MS40

MS40 was a new ECU for BMW, manufactured by Siemens instead of the previous Bosch Motronics. BMW split the M50 24v engines and used Siemens for some of the 2.0 litres, and Bosch continued on with the 2.5l.

MS40.0 is a rare ECU used on non VANOS 2.0l, and MS40.1 introduced VANOS control.

Ignition Current- Bank 2

Fault Code Table : DME MSS50

The MSS50 is a special ECU designed solely for the European E36 M3 3.2. Designed by Siemens, it integrates full Vanos control for both Intake and Exhaust Cams inside a single ECU, unlike the previous M3.3 which required a separate VNC Vanos Controller

Knock Sensor- Cyl 1-2

Fault Code Table : DME MSS52

The MSS52 is an M Power ECU designed to run the E39 M5, the Z8 Roadster, and also the Wiesmann Roadsters. The MSS54 is used on the E46 M3 and on some Z3Ms. The system uses an Electronic Throttle to accurately control Air intake instead of the more common Cable throttles used on earlier vehicles

Knock Sensor- Cyl 1-2

Fault Code Table : DME MSS54

Rear Right ABS Valve

Fault Code Table : ABS 1

The first BMW ABS system, This was a 3 channel system, controlling braking to the front wheels,and a single line for both rear wheels. The wheel speed info could be passed via data lines to traction control systems, which could determine if the vehicle speed signal given from the rear driven axle did not match with the front wheel speed signals and request torque reduction intervention from the ASC (Anti Skid Control) throttle body.

ABS Valve Fault Rear Right

Fault Code Table : ABS 2

The updated version of BMW’s ABS system, this was more advanced. Improvements include a 4 channel system for independent rear wheel braking, which allowed a more active ASC system. With individual braking, not only could a torque reduction be requested via the ASC secondary throttle body, but independent wheel braking could be used to control individual wheel slip as part of a stability program.