System: Vehicle Immobilizer
BMW System: EWS
Type: Drive
System: Vehicle Immobilizer
BMW System: EWS
Type: Drive
DME Control Unit
The next generation Siemens MS ECUs introduced many of the OBD2 features. This includes Catalytic Converter monitoring and Long / Short term Fueling and Ignition Adaptation. The MS41 was used on the M52 series of engines, MS42 on the M52TU series, and MS43 on the M43 4 Cylinders.
The OBD2 P codes fault protocol was not activated in European markets on this group, as currently it was not required by law.
DME Control Unit
The next generation Siemens MS ECUs introduced many of the OBD2 features. This includes Catalytic Converter monitoring and Long / Short term Fueling and Ignition Adaptation. The MS41 was used on the M52 series of engines, MS42 on the M52TU series, and MS43 on the M43 4 Cylinders.
The OBD2 P codes fault protocol was not activated in European markets on this group, as currently it was not required by law.
DME Control Unit
The next generation Siemens MS ECUs introduced many of the OBD2 features. This includes Catalytic Converter monitoring and Long / Short term Fueling and Ignition Adaptation. The MS41 was used on the M52 series of engines, MS42 on the M52TU series, and MS43 on the M43 4 Cylinders.
The OBD2 P codes fault protocol was not activated in European markets on this group, as currently it was not required by law.
VANOS Retard Valve- Intake
The MSS50 is a special ECU designed solely for the European E36 M3 3.2. Designed by Siemens, it integrates full Vanos control for both Intake and Exhaust Cams inside a single ECU, unlike the previous M3.3 which required a separate VNC Vanos Controller
VANOS Retard Valve- Inlet Bank 1
The MSS52 is an M Power ECU designed to run the E39 M5, the Z8 Roadster, and also the Wiesmann Roadsters. The MSS54 is used on the E46 M3 and on some Z3Ms. The system uses an Electronic Throttle to accurately control Air intake instead of the more common Cable throttles used on earlier vehicles
VANOS Retard Valve- Inlet Bank 1
The MSS52 is an M Power ECU designed to run the E39 M5, the Z8 Roadster, and also the Wiesmann Roadsters. The MSS54 is used on the E46 M3 and on some Z3Ms. The system uses an Electronic Throttle to accurately control Air intake instead of the more common Cable throttles used on earlier vehicles
Misfiring with Cylinder Cutout Cyl 10
DME M5.2 and M5.2.1 are Bosch ECUs, used on the M44 4cyl engine, and the M62 V8, and the M72 V12.
Misfiring with Cylinder Cutout Cyl 10
DME M5.2 and M5.2.1 are Bosch ECUs, used on the M44 4cyl engine, and the M62 V8, and the M72 V12.
CAN BUS
DDE 3 is the BMW name for the ECUs used on the M47 range on Diesel engines, also known as he Bosch EDC15. These are 4 Cylinder diesels, used in the E46 320d, and uses Common Rail Injection. Common Rail systems use a high pressure fuel rail with diesel injectors, as opposed to the mechanical injection systems, or the PD (Pumpe Düse) system where each injector also acts as a high pressure pump.
Internal Fault
The updated version of BMW’s ABS system, this was more advanced. Improvements include a 4 channel system for independent rear wheel braking, which allowed a more active ASC system. With individual braking, not only could a torque reduction be requested via the ASC secondary throttle body, but independent wheel braking could be used to control individual wheel slip as part of a stability program.
Copyright © 2019 All rights reserved. BMW Faults are listed in here BMWFaultCodes.com .
If you have own an another brand car/vehicle to check fault codes like : Audi Fault Code | Volvo Fault Codes