System: Engine Electronics
BMW System: DME-DDE
Type: Drive
System: Engine Electronics
BMW System: DME-DDE
Type: Drive
CAN bus error -EGS Signal not present
The next generation Siemens MS ECUs introduced many of the OBD2 features. This includes Catalytic Converter monitoring and Long / Short term Fueling and Ignition Adaptation. The MS41 was used on the M52 series of engines, MS42 on the M52TU series, and MS43 on the M43 4 Cylinders.
The OBD2 P codes fault protocol was not activated in European markets on this group, as currently it was not required by law.
CAN bus error -EGS Signal not present
The next generation Siemens MS ECUs introduced many of the OBD2 features. This includes Catalytic Converter monitoring and Long / Short term Fueling and Ignition Adaptation. The MS41 was used on the M52 series of engines, MS42 on the M52TU series, and MS43 on the M43 4 Cylinders.
The OBD2 P codes fault protocol was not activated in European markets on this group, as currently it was not required by law.
CAN bus error -EGS Signal not present
The next generation Siemens MS ECUs introduced many of the OBD2 features. This includes Catalytic Converter monitoring and Long / Short term Fueling and Ignition Adaptation. The MS41 was used on the M52 series of engines, MS42 on the M52TU series, and MS43 on the M43 4 Cylinders.
The OBD2 P codes fault protocol was not activated in European markets on this group, as currently it was not required by law.
Lambda Sensor Pre Cat Bank 2 Flip Time
The MSS52 is an M Power ECU designed to run the E39 M5, the Z8 Roadster, and also the Wiesmann Roadsters. The MSS54 is used on the E46 M3 and on some Z3Ms. The system uses an Electronic Throttle to accurately control Air intake instead of the more common Cable throttles used on earlier vehicles
Lambda Sensor Pre Cat Bank 2 Flip Time
The MSS52 is an M Power ECU designed to run the E39 M5, the Z8 Roadster, and also the Wiesmann Roadsters. The MSS54 is used on the E46 M3 and on some Z3Ms. The system uses an Electronic Throttle to accurately control Air intake instead of the more common Cable throttles used on earlier vehicles
CAN Interface EML Timeout
DME M5.2 and M5.2.1 are Bosch ECUs, used on the M44 4cyl engine, and the M62 V8, and the M72 V12.
CAN Interface EML Timeout
DME M5.2 and M5.2.1 are Bosch ECUs, used on the M44 4cyl engine, and the M62 V8, and the M72 V12.
Copyright © 2019 All rights reserved. BMW Faults are listed in here BMWFaultCodes.com .
If you have own an another brand car/vehicle to check fault codes like : Audi Fault Code | Volvo Fault Codes