Logo

BMW Fault Code - 137

Check 137 Fault Code

BMW Fault Code: 137

137 - Fault during offset test in potentiometer 2 of throttle valve 1 (OBDII code P1545)

System: Electronic Engine Power Control

BMW System: EML

Type: Drive

CAN Signal -Steering Angle Sensor

Fault Code Table : MS41

The next generation Siemens MS ECUs introduced many of the OBD2 features. This includes Catalytic Converter monitoring and Long / Short term Fueling and Ignition Adaptation. The MS41 was used on the M52 series of engines, MS42 on the M52TU series, and MS43 on the M43 4 Cylinders.

The OBD2 P codes fault protocol was not activated in European markets on this group, as currently it was not required by law.

CAN Signal -Steering Angle Sensor

Fault Code Table : MS42

The next generation Siemens MS ECUs introduced many of the OBD2 features. This includes Catalytic Converter monitoring and Long / Short term Fueling and Ignition Adaptation. The MS41 was used on the M52 series of engines, MS42 on the M52TU series, and MS43 on the M43 4 Cylinders.

The OBD2 P codes fault protocol was not activated in European markets on this group, as currently it was not required by law.

CAN Signal -Steering Angle Sensor

Fault Code Table : MS43

The next generation Siemens MS ECUs introduced many of the OBD2 features. This includes Catalytic Converter monitoring and Long / Short term Fueling and Ignition Adaptation. The MS41 was used on the M52 series of engines, MS42 on the M52TU series, and MS43 on the M43 4 Cylinders.

The OBD2 P codes fault protocol was not activated in European markets on this group, as currently it was not required by law.

CAN Protocol Fault

Fault Code Table : DME MSS50

The MSS50 is a special ECU designed solely for the European E36 M3 3.2. Designed by Siemens, it integrates full Vanos control for both Intake and Exhaust Cams inside a single ECU, unlike the previous M3.3 which required a separate VNC Vanos Controller

Knock Sensor 1

Fault Code Table : BMS46

The Bosch BMS46 is a Hybrid ECU, created from a joint effort with Siemens, and is used in later M43 engines used in the Z3 and E46 series.

Knock Sensor 1

Fault Code Table : BMS43

The Bosch BMS46 is a Hybrid ECU, created from a joint effort with Siemens, and is used in later M43 engines used in the Z3 and E46 series.

About | Contact | Privacy

Copyright © 2019 All rights reserved. BMW Faults are listed in here BMWFaultCodes.com .

If you have own an another brand car/vehicle to check fault codes like : Audi Fault Code | Volvo Fault Codes